Coltene S.P.E.C. 3 LED Benutzerhandbuch Seite 7

Owner's Guide
III. Parts and Descriptions
As you remove each item from the box, ensure all box contents
are in good condition. If items are missing or damaged, contact
your supplier for immediate assistance.
3
2
1
7
Owner's Guide
11
1. HANDPIECE The handpiece is equipped with high-power
LEDs and its control panel is located on the
front part.
2. LIGHT GUIDE The output of the Curing Light LED is emitted
from the end of this piece (autoclavable).
(8MM TURBO)
3. LIGHT SHIELD This shield protects the eyes from the light
emimited from the light guide during use.
4. CHARGER BASE The charger base is for the cordless curing
light only. Always place the handpiece on the
(6V DC, 2.5A)
charger base when not in use.
5. POWER ADAPTER Please use the original power adapter at all
times.
6. AC POWER CORD Please use original AC power cord (at all
times).
7. OWNER'S GUIDE S.P.E.C. 3
8. BARRIER SLEEVES Use for infection control.
Test curing times and depth of cure.
9. COMPOSITE CURING
TEST BLOCK
4
5
6
8
9
10
12
® LED Curing Light Owner's Guide.
EN
10. PHILLIPS HEAD SCREW
DRIVER
11. HANDPIECE COVERED
BY BARRIER SLEEVE
12. EYE SHIELD
IV. Installation
IMPORTANT
• For proper operation, the power adapter and charger
base must be installed and used in a dry environment.
If the charger base becomes wet, unplug it immediately
and dry thoroughly before plugging it in and inserting the
handpiece.
• Do not place the handpiece into the charger base
until it has reached room temperature. Humidity and
condensation could damage the electronics.
• The power adapter is designed for use within a voltage
range from 100-240V, 50-60Hz. Ensure that the required
voltage is available before connecting the power cord
to the power adapter. Failure to do so may damage the
electronics.
• Use only the power adapter supplied by COLTENE with
®
the S.P.E.C. 3
• Do not use the device unless the power cord is firmly
inserted into the electrical outlet.
Connecting the S.P.E.C. 3
1. Insert the power adapter cord (Fig. 5) into the receptacle
in the charger base (Fig. 4).
2. Place the charger base on a level and secure surface.
3. Insert the AC power cord (Fig. 6) into the power adapter
(Fig. 5).
4. Plug the other end of the AC power cord (Fig. 6) into an
electrical wall outlet.
Use to remove the battery pack.
Place Eye Shield over both.
This shield protects the eyes from the light
emitted from the light guide during use.
LED Curing Light.
® LED Charger Base:
7