Coltene S.P.E.C. 3 LED Benutzerhandbuch Seite 5

Owner's Guide
2.2. Transport damage
Check the device for any damage after receiving it. If damaged,
immediately report to the transportation company within 24
hours from the date of receipt. Under no circumstances, work
with a damaged curing light.
2.3. Operator's obligations
Users must be trained and comply with state or local regulations
in force for this type of device.
2.4. Safety instructions
Before putting the device into operation, read this manual
thoroughly and follow the instructions to avoid any misuse or
damage especially related to user and patient's health. Do not use
this device without proper eye protection for the operator,
assistant and patient.
• Before using the device, check the power
cord and plug for damage. If they are
damaged, do not connect the equipment
to the mains power.
• Do not immerse the product in water.
Moisture should be avoided. Electric
WARNING
shock could occur.
• Keep the product in a dry and clean
place. Exposure to moisture increases
the risk of electric shock.
• Failure to comply may result in injury or
death to personnel.
Only use authorized spare parts and accessories supplied by
.
COLTENE Use of parts other than those recommended may
damage circuitry and will void product warranty. Repair or
disassembly of this device beyond the scope of what is listed
in these Instructions for Use must be done by authorized
personnel only.
Electric Shock Hazard
EN
COLTENE is not responsible for any damage caused by the
following:
• Improper repair or maintenance service performed by
unauthorized personnel or facilities.
• Use of any unauthorized replacement parts or accessories.
• S.P.E.C. 3
high-output light energy. Do not look
directly at the light emitted from this
curing light. Retinal damage may ocurr.
• Patient, clinician and assistants should wear
UV orange eye protection when this device
is in use. Retinal damage may occur.
WARNING
• After use, place the handpiece on the
charger base securely. Failure to properly
secure the handpiece in the charger base
may result in an incomplete battery charge.
• Light output from this light may be
significantly increased compared to other
polymerization devices; therefore when
using this device determine the curing time
of your material using the enclosed test
CAUTION
block.
• Do not drop the handpiece or light guide.
Device damage may occur.
• Avoid electromagnetic radiation generated
from other electrical appliances, as they may
cause the product to malfunction.
® LED Curing Light produces
5