High Temperatures - Risk Of Burns - Gastroback DESIGN ESPRESSO ADVANCED BARISTA Bedienungsanleitung

of your mains power supply corresponds to the voltage requirements of
the appliance (220 - 240 V, 50 - 60 Hz, AC, rated for at least 16 A). The
power outlet socket must be installed separately from other power outlet
sockets to avoid interference with other appliances.
The installation of a residual current operated circuit breaker (r.c.c.d.)
with a maximum rated residual operating current of 30 mA in the supp-
lying electrical circuit is strongly recommended. If in doubt, contact your
electrician for further information.
• In various foreign countries, the specifications for power supplies are
subject to incompatible norms. Therefore it is possible that power sup-
plies in foreign countries do not meet the requirements for safe opera-
tion of the appliance. Thus, before operating the appliance abroad,
ensure that safe operation is possible.
• Do not use any desk top multi socket outlet, external switching device,
or remote control systems, or extension cord to avoid risk of fire or
electric shock. Ensure that the power outlet socket used is always
accessible for unplugging the appliance immediately in case of mal-
function or danger.
• The appliance may not be operated on metal surfaces (e.g. sink) to
avoid risk of electric shock. Do not touch the power plug or the appli-
ance with wet hands, when the appliance is connected to the power
supply.
• DO NOT pour or spill any liquids on or under the housing of the appli-
ance or the power cord. Do not overfill the water tank (max. 2.5 litres,
2500 ml; MAX filling line). Otherwise, water could run out and cau-
se hazards due to overheating, fire and electric shock. Always wipe
off spilled liquids immediately. If liquids run out or are spilled on the
housing, immediately unplug the appliance. Do not immerse the appli-
ance, power cord, or power plug in water or other liquids. Do not
place the appliance on wet surfaces. When liquids are spilled on the
power cord or operating elements (console, selection dial, or grind
size dial) or accumulate under the appliance, immediately unplug the
appliance. Thereafter, dry the appliance and let it dry naturally for at
least 1 day. If in doubt, carefully check the appliance for leakage.
EN
84
• Always completely unwind the power cord before use. Power cords
may never be knotted, twisted, strained or squeezed. Do not let the
power plug or power cord hang over the edge of the table or counter.
The power cord may not touch hot surfaces or sharp edges. Ensure
that no one will pull the appliance by the power cord. Take care not
to entangle in the power cord. Always grasp the power plug, when
disconnecting the power cord.
HIGH TEMPERATURES – RISK OF BURNS
Your new Design Espresso Advanced Barista is designed for extracting
coffee and producing hot water and hot steam under high pressure. Thus,
some parts (e.g. lower part of the group head, portafilter, filter basket,
steam wand) will get very hot during operation and hot steam and water
may escape during operation and shortly thereafter. Please adhere to
the following precautions to avoid injuries and damage.
• Do not hold your hands and arms or any delicate objects under or
near the portafilter, group head, or steam wand during operation and
while the appliance is still hot. Only touch the portafilter and steam
wand at the dedicated handles. Always ensure that the steam wand
points to the drip tray or in a suited vessel, when it is not in use. Only
use heat-resistant vessels with the appliance to avoid damage and
severe injuries due to splinters and hot liquids. For texturing milk, do
not use glasses or plastic vessels, because even heat-resistant glass
or plastic could crack or melt due to extreme local heating during
texturing. Therefore, splinters and chemicals could get into your beve-
rages, causing severe injuries and influencing your well-being.
• Before extraction, always ensure that the portafilter is installed firmly
and correctly at the group head. Do not remove the portafilter from
the group head during extraction (espresso button flashes) to avoid
severe risk of burns.
• If water comes out at the rim of the portafilter, immediately stop the
extraction cycle (press the flashing button) and wait, until the pointer
of the pressure gauge is back at the left stop (at least 10 seconds).
Thereafter, carefully remove the portafilter (see: 'Care and Cleaning').
EN
85