Inhaltsverzeichnis
Werbung
Zero mm
Zero mm
(Zero in)
(Zero in)
HANDLEBAR
6. Install:
• Throttle cable cap 1
• Screw (throttle cable cap) 2
WARNING
After tightening the screws, check that the
throttle grip 3 moves smoothly. If it does
not, retighten the bolts for adjustment.
7. Install:
• Cover (grip cap) 1
• Cover (throttle cable cap) 2
8. Install:
• Start switch 1
• Master cylinder 2
• Master cylinder bracket 3
• Bolt (master cylinder bracket) 4
• Clamp 5
NOTE:
• The start switch and master cylinder bracket
should be installed according to the dimen-
sions shown.
• Install the bracket so that the arrow mark a
faces upward.
• First tighten the bolt on the upper side of the
master cylinder bracket, and then tighten the
bolt on the lower side.
5 - 43
CHAS
4 Nm (0.4 m · kg, 2.9 ft · lb)
9 Nm (0.9 m · kg, 6.5 ft · lb)
Werbung
Inhaltsverzeichnis
