Inhaltsverzeichnis
Werbung
AC MAGNETO AND STARTER CLUTCH
2
1
1
5. Install:
3
1
NOTE:
Tighten the rotor nut to 65 Nm (6.5 m • kg,
47 ft • lb), loosen and retighten the rotor nut to
65 Nm (6.5 m • kg, 47 ft • lb).
6. Install:
NOTE:
Apply the engine oil on the shaft, bearing and
idle gear inner circumference.
7. Install:
NOTE:
Tighten the bolts in stage, using a crisscross
pattern.
8. Install:
NOTE:
Apply the engine oil to the shaft and plain
washers.
4 - 84
• Bolt (starter clutch) 1
16 Nm (1.6 m · kg, 11 ft · lb)
• Plain washer (rotor)
• Nut (rotor) 2
65 Nm (6.5 m · kg, 47 ft · lb)
Use the sheave holder 3.
Sheave holder:
YS-1880-A/90890-01701
• Shaft 1
• Bearing 2
• Idle gear 2 3
• Dowel pin
• Gasket [crankcase cover (left)]
• Crankcase cover (left) 1
• Bolt [crankcase cover (left)]
10 Nm (1.0 m · kg, 7.2 ft · lb)
• Plain washer
• Torque limiter 1
• Plain washer
ENG
New
Werbung
Inhaltsverzeichnis
