Sps-Steuerprogrammablauf Des Pmm; Interne Zustände - primes PowerMeasuringModule PMM Originalbetriebsanleitung

PowerMeasuringModule PMM AP3sM
9.3

SPS-Steuerprogrammablauf des PMM

Start & Status.
Absorber too hot == 1
9.4 Interne Zustände
Automatisch
Statusbit Measurement finished == 1
Revision 01 DE - 04/2023
Vorbereitung
Do Reset
Open Shutter
Do Start
Do Laser pulse
Shutter.err == 1
Wait Running
Close Shutter
Shutter.err == 1
Read Results
Command
"do_reset"
Ready for Measurement
Start

Start & Status.PMM is
idle == 0
 Status.PMM is idle == 1
 Status.Shutter is open == 1
 Status.Ready for measurement == 1

 Status.Measurement running == 1
 Status.Measurement finished == 1

Ende
PMM is idle
Command "Start Measurement"
Statusbit Shutter is open == 1
Calculate Power
Start & Status.PMM is
idle == 1
&
Laserpuls
45