Beyerdynamic MCS Bedienungsanleitung Seite 39

1.2.1 Chairman Microphone Unit
The chairman microphone unit is equipped with 3 buttons.
Priority button: The function of the priority button depends on how it has been configured in the MCS 100 discussion control unit. The
chairman can either mute or clear all activated delegate microphone units.
Microphone button: The microphone button allows the chairman to switch on his microphone unit independingly from the number
of open microphones at any time.
Clear button: Pressing the clear button, the chairman clears all activated microphone units, including his own. In the Request-to-Talk
mode all registered microphone units are also cleared.
1.2.2 Delegate Microphone Unit
The delegate microphone unit is equipped with 1 button, the microphone button. Using this button, the delegates can switch
their microphone unit on and off or register in the Request-to-Talk mode.
If a delegate microphone unit has been configured as a chairman microphone unit via the MCS-Editor software (refer also to chapter
"6. MCS 100 system configuration via MCS-Editor") it does not depend on the NOM any more i.e. it can be switched on at any time,
as it receives automatically the status of the chairman microphone unit. Furthermore, the microphone button can be configured as a
priority button (refer to chapter "1.3 Addressing the microphone units").
Important
• To avoid overstretching and premature wear and tear, always adjust the gooseneck microphone via the lower flexible
part of the microphone and never the microphone head or rigid tube. The gooseneck can only be bent 90° at maximum.
1.3 Maintenance of the MCS Microphone Units
For cleaning the MCS microphone units when they are slightly dirty (finger prints, dust, jam or juice) use a soft, damp cloth,
sponge or brush and a liquid cleaning agent. Before cleaning the surface it must be moistened thoroughly. Afterwards it must be
cleaned with clear water. Make sure not to allow any water to enter the unit. For dirt caused by mineral oils and fats, animal and
vegetable fats use spirit, isopropyl alcohol or benzine.
For dirt caused by ballpoint pens, typewriter ribbons or carbon paper use isopropyl alcohol or spirit.
Clean the supplied pop shield with clear water. Make sure that it is completely dry before you put it on the microphone again.
39