Adjusting The Programs; Step 1: Selecting The Handpiece/Contra Angle To Be Used - Nouvag MD11 Bedienungsanleitung

MD 11
7.4

Adjusting the programs

The values for operation settings depend on the connected handpiece/contra angle as well as the task to be
performed.
7.4.1

Step 1: Selecting the handpiece/contra angle to be used

The selected handpiece/contra angle must comply with the factual used handpiece/contra angle.
Press the "HP" key to select the handpiece/contra angle
Press the "PR" key to choose between program 1 to 6. The factory setting is adjusted to 4 usable
programmes.
In the configuration menu the number of available programs can be set from 2 to 6 (refer to "7.8
configuration menu/number of programs").
Table of possible handpiece/contra angles
Name of the
handpieces/contra angles
with transmission ratio
Drill handpiece, 1:1
Drill contra angle, 16:1
Drill contra angle, 20:1
Drill contra angle, 32:1
Drill contra angle, 70:1
* The limitation of the AS-range (Automatic Stopper) can be adjusted in the configuration menu.
Handpieces or contra angles that don't belong to one's own assortment can be deactivated in the Configuration
Menu (refer to "7.8 configuration menu/handpiece existing"). That makes finding the right handpiece in the
handpiece list easier, because the list of available handpieces becomes shorter.
MD 11, V2.0, Operating Instructions, REF 31665, V22/17
Speed Speed
Display min. rpm max. rpm
1 : 1 300 40,000
16 : 1 20
20 : 1 15
32 : 1 10
70 : 1 5
Torque Torque
min. Ncm max. Ncm
1 6
2400 5 27
1700 10 70
1000 10 55
600 10 55
Limit
AS-range
AS-range
(Factory def.)
rpm rpm (*)
- –
up to 20 20 – 45 *
up to 20 15 – 45 *
up to 20 10 – 45 *
up to 20 5 – 45 *
13
EN