Overview: Standard Display - Nouvag MD11 Bedienungsanleitung

7.3

Overview: Standard display

A
B
C
D
E
E
A) Information Line
Information and error messages are displayed here. Display is illuminated red at error messages.
At standby the display shows "Nouvag AG – MD 11 V2.0" including the indication of device history.
B) Program
Shows the selected program number 1 to 6. The factory setting is adjusted to 4 usable programmes.
In the configuration menu the number of available programs can be set from 2 to 6 (refer to "7.8
configuration menu/number of programs").
C) Pump
The numerical value shows the pump flow rate in percent and the drop symbol together with the
on/off indication shows if the pump is in stand-by mode or switched off.
D) Rotational direction of the motor
The arrow indicates the rotational direction set for the motor. Change the rotation direction by
pressing the button "FOR/REV" on the pedal.
E) Current speed
At stand still of the device the set maximum speed is displayed. If pedal is activated and motor
begins to run the current speed is displayed in real time.
F) Transmission ratio of contra angle
Shows transmission ratio of used contra angle, e.g. 1:1, 16:1, 20:1, 32:1 or 70:1.
G) Speed range
Shows speed range of the handpiece used.
H) Maximum torque
Shows maximum torque setting.
I) Bar graph (current torque)
The bar graph is providing a graphical representation of the current torque. All bars active means
max. torque reached.
J) AS/AL
Indication of the Auto Stopper (AS) mode or the Automatic Limiter (AL) mode, (see chapter "7.5
Torque limit function, AL mode" and chapter "7.6 Torque limit function, AS mode").
The pump does not begin to operate until the motor has been activated by pressing the pedal.
12 MD 11, V2.0, Operating Instructions, REF 31665, V22/17
MD 11
G
H
I
F
G
H
I
J