Operation; Switching The Device On And Off; Overview: Control Elements On The Operating Panel - Nouvag MD11 Bedienungsanleitung

MD 11
7

Operation

7.1

Switching the device on and off

The power switch "I/O" (at the rear) is used to switch the control unit on and off.
The device can be switched off at any time irrespective of any procedure for switching off the device.
7.2

Overview: control elements on the operating panel

A
A) Display: Shows the operating values (See chapter "7.3 Overview: Standard display").
B) "Handpiece" key: Selection of the required handpiece/contra angle
The factory default settings contain the handpiece/contra angles 1:1, 16:1, 20:1 and 32:1. If you want to use
your 70:1 contra angle it has to be activated in the configuration menu (refer to "7.8 Configuration menu/
handpiece existing").
C) "Program" key: Selection of program 1 to 6. The factory setting is adjusted to 4 usable programmes.
The number of usable porgrams can be altered from 2 to 6 available programs (refer to „7.8 Configuration
menu/handpiece existing").
By pressing both „HP + PR" keys at the same time the programs can be reset to the factory default setting.
D) "Speed" keys:
Restrict the maximum speed that can be selected using the pedal.
"▲": increases the maximum speed
By pressing both "Speed" keys at the same time "Speed ▲ + ▼" the handpiece calibration will be started
(refer to "7.4.2 Calibrating handpieces").
E) "Torque" keys:
Restricts the maximum torque.
"▲": increases the maximum torque
By pressing both "Torque" keys at the same time "Torque ▲ + ▼" the torque modes AL or AS are selected
(see chapter "7.5 Torque limit function, AL mode (Automatic Limiter)" and chapter
"7.6 Torque limit function, AS mode (Automatic Stopper)").
If a speed of 20 rpm is set, irrespective of the selected handpiece/contra angle, the pressing of both torque
keys, "Torque ▲ + ▼" causes the activation of the thread cutting function.
F) "Pump" keys:
Adjusting the maximal pump flow rate, recalled by the pedal.
"▲": increases the maximum supply quantity
By pressing both "Pump" keys at the same time "Pump ▲ + ▼" the pump will be put on call, pressing again
will switch it off.
MD 11, V2.0, Operating Instructions, REF 31665, V22/17
"▼": reduces the maximum speed
"▼": reduces the maximum torque
"▼": reduces the maximum supply quantity
EN
B
C
D
E
F
11