Adjusting The Programs; Step 1: Selecting Handpiece Or Transmission Ratio - Nouvag OFA-Drill Bedienungsanleitung

7.4

Adjusting the programs

Values for operation settings depend on the connected handpiece as well as the task to be performed.
7.4.1

Step 1: Selecting handpiece or transmission ratio

Depending on the handpiece attached to the motor, the corresponding handpiece (transmission ratio) has
to be selected by using the "HP" key. Make sure the display shows the correct handpiece.
Press «HP» key to select the handpiece.
Parameter of handpieces
Name of handpiece/
transmission ratio
Handpiece, 1 : 1
Handpiece 4 : 1
Micro oszillating saw
Micro sagittal saw
Micro compass saw
K-Wire handpiece
OFA-Drill operating instructions, ref. 31595, V49/15
Handpiece name Speed
on Display min. rpm
1 : 1 300
4 : 1 200
Micro saw
Kirschner Hp 500
Speed
max. rpm min. Ncm
50,000
12,000
fix 15,000
2,800
Torque Torque
max. Ncm
1 6
1 18
fix 6
fix 48
EN
11