Startup; Setting Up The Device; Device Preparation - Nouvag Mesher Bedienungsanleitung

6

Startup

6.1

Setting up the device

● The working height for accessing the Mesher is ideal if a standing position is assumed with arms slightly
bent. Often the Mesher needs to be pressed down, while with the other hand the ratchet is accessed. To
route the occurring forces to the direction of gravity the ratchet is preferably pulled from a less than
vertical position down to the table.
● Place the sterilized Mesher, with all required parts on an even, non slip surface and make sure to have
good access to all controls.
● Do not allow the operating range of the device to be compromised by limiting factors.
● The insertion slot and the exit side of the Mesher must be fully visible at all times.
6.2

Device preparation

1. Set the pull and twist knob to one of the positions, which is most suitable for the intended to use mesh
board. The blades on the blade roll must completely penetrate the skin section on the mesh board to
ensure a uniform extension of the skin section. The pressure of the blade roll on the mesh board with
the skin section must be relatively high to achieve clean perforations of the skin section.
2. Align the marking on the transport ratchet with the flattened part of the axis of the blade roll and join it.
6
Mesher, skin expansion system
Operating instructions Mesher, Ref. 31584, V32/15