Yamaha WR250F 2001 Fahrer- Und Wartungshandbuch Seite 556

2
1
B
HANDLEBAR
7. Install:
Light switch 1
8. Install:
Engine stop switch 1
Clutch lever holder 2
Bolt (clutch lever holder) 3
Decompression lever holder 4
Bolt (decompression lever holder) 5
Clamp 6
NOTE:
The engine stop switch, clutch lever holder,
decompression lever holder and clamp
should be installed according to the dimen-
sions shown.
Pass the engine stop switch lead in the mid-
dle of the clutch holder.
9. Install:
Clutch cable 1
Decompression cable 2
NOTE:
Apply the lithium soap base grease on the
clutch cable end and decompression cable
end.
10. Adjust:
Clutch lever free play
Refer to "CLUTCH ADJUSTMENT"
section in the CHAPTER 3.
Decompression lever free play
Refer to "DECOMPRESSION LEVER
ADJUSTMENT" section in the CHAP-
TER 3.
5 - 45
CHAS
2 Nm (0.2 m · kg, 1.4 ft · lb)
4 Nm (0.4 m · kg, 2.9 ft · lb)
4 Nm (0.4 m · kg, 2.9 ft · lb)