Inhaltsverzeichnis
Werbung
DRIVE CHAIN SLACK ADJUSTMENT
3 - 34
5. Install:
Chain joint 1
O-ring 2
Drive chain 3
NOTE:
When installing the drive chain, apply the lith-
ium soap base grease on the chain joint and
O-rings.
6. Install:
Link plate 4
NOTE:
Press the link plate onto the chain joint using
a chain rivetter 5.
Rivet the end of the chain joint using a chain
rivetter 6.
After rivetting the chain joint, make sure its
movement is smooth.
7. Lubricate:
Drive chain
Drive chain lubricant:
SAE 10W-30 motor oil or suit-
able chain lubricants
EC36A060
DRIVE CHAIN SLACK ADJUSTMENT
1. Elevate the rear wheel by placing the
suitable stand under the engine.
2. Check:
Drive chain slack a
Above the seal guard installation bolt.
Out of specification → Adjust.
Drive chain slack:
40 ~ 50 mm (1.6 ~ 2.0 in)
NOTE:
Before checking and/or adjusting, rotate the
rear wheel through several revolutions and
check the slack several times to find the tight-
est point. Check and/or adjust chain slack with
rear wheel in this "tight chain" position.
INSP
ADJ
Werbung
Inhaltsverzeichnis
