Inhaltsverzeichnis
Werbung
REAR BRAKE PAD INSPECTION AND REPLACEMENT
Install the pad pin plug B.
Pad pin plug:
3 Nm (0.3 m • kg, 2.2 ft • lb)
3. Inspect:
Brake fluid level
Refer
to
INSPECTION" section.
4. Check:
Brake lever operation
A softy or spongy feeling → Bleed
brake system.
Refer
to
BLEEDING" section.
REAR BRAKE PAD INSPECTION AND
REPLACEMENT
1. Inspect:
Brake pad thickness a
Out of specification → Replace as a
set.
Brake pad thickness:
6.4 mm (0.25 in)
<Limit>: 1.0 mm (0.04 in)
2. Replace:
Brake pad
Brake pad replacement steps:
Remove the protector 1 and pad pin plug
2.
Loosen the pad pin 3.
Remove the rear wheel 4 and brake cali-
per 5.
Refer to "FRONT WHEEL AND REAR
WHEEL" section in the CHAPTER 5.
3 - 30
INSP
ADJ
"BRAKE
FLUID
LEVEL
"BRAKE
SYSTEM
AIR
Werbung
Inhaltsverzeichnis
