Safety Notes; Intended Use; Signal Words; Eu Declaration Of Conformity - Fluke PRUFTECHNIK PULLALIGN Bedienungsanleitung

6

Safety notes

Safety notes

Intended use

PULLALIGN is designed for use in industrial environments where
pulley systems have to be aligned. Due to its simplicity, alignment
using PULLALIGN requires only one operator.
PRÜFTECHNIK assumes no liability for damage or injury resulting
from uses other than those described in this document.

Signal words

The following signal words panels are used in this document to
draw attention to important sections of text. The sections of text
provide useful information in using PULLALIGN.
Notice
Notice is used for general information and tips regarding
operation of PULLALIGN. It addresses practices not related
to personal injury.
Warning
Warning is used for potential hazard, which if not avoided,
could result in minor or moderate injury.

EU declaration of conformity

PULLALIGN laser conforms to all relevant EU Guidelines as
indicated in its respective declaration of conformity. This declara-
tion of conformity may be downloaded at:
www.pruftechnik.com/downloads/certificate/ce-certificate-
overview.html

Laser safety

PULLALIGN system uses either PULLALIGN laser ALI 2.100
(red laser) or PULLALIGN Lite 2 laser ALI 2.131 (green laser).
According to IEC 60825-1:2014, both laser units are classified as
Class 2 laser products. They comply with 21 CFR 1040.10 and
1040.11 except for deviations pursuant to Laser Notice No.50,
dated June 24, 2007. The lasers operate at a wavelength of 630
– 680 nm (red laser) and 505 – 535 nm (green laser) respectively.
They have a maximum radiant power < 2.8 mW. The radiant
power determined according to IEC 60825-1:2014 condition 3
is < 1.0 mW. No maintenance is necessary to keep the products
compliant as outlined above.