Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Commissioning
Disconnect the power supply cord
➜
Switch OFF the device at the main switch before disconnecting the power supply
cord (see following section "Switching the device on/off" on page 66).
➜
Disconnect the mains connection cord from the mains socket-outlet.
➜
Press in the locking lever on the cable coupling and disconnect the power supply
cord from the IEC appliance plug on the back of the device.
Switching the device on/off
To switch the device on and off, use the main switch on the front of the device below
the control panel:
➜
Press the main switch once until it locks into place.
–
The display is switched on automatically.
–
The welcome screen appears.
–
The main menu is opened (Hei-TORQUE Ultimate only).
➜
Press the main switch again to switch off the device.
–
The main switch is released and jumps back to the original position.
Automatic restart
This function can be used to set the device so that the stirrer is restarted automatically
in the following cases, and the speed is run up to the last set value:
–
on switching on the device, if it was switched off before hand without actively
stopping the rotational movement using the [
(see section "Stirrer on/off swipe field" on page 60);
–
when the power is restored after a system power supply outage.
CAUTION
➜
➜
➜
Proceed as follows to activate/deactivate the automatic restart function:
Always activate or deactivate the automatic restart function as
required before the actual process start!
Pay attention to the safety symbols on the device for signaling
the functional status for all process sequences.
If the automatic restart function is active, secure the device
with an information sign if necessary (in the appendix to this
document).
Stirrer on/off
66
] swipe field
Werbung
Inhaltsverzeichnis
