Modifications To The Device; Employee Safety; Safety During Use; Disposal - Heidolph Hei-MIX Promax 2020 Originalbetriebsanleitung

Safety Instructions
▪ The device is designed for indoor use only and under the following ambient conditions:
Ambient temperature 5 - 31 °C at 80 % relative humidity
32 - 40 °C decreasing linearly to a
maximum 50 % relative humidity
Installation altitude 0 - 2,000 m above sea level
Contamination level 2
Overvoltage category II
Permissible supply deviations ± 10 %
▪
If the device is operated in corrosive atmospheres, the service life of the device will
decrease based on the concentration, duration and frequency of the exposure to the
corrosive atmosphere e.g. concentrated hydrochloric acid (HCI).

Modifications to the device

▪ It is not permitted to make any unauthorised modifications or changes to the device.
▪
Do not attach or install any parts that have not been approved by the manufacturer.
▪ Unauthorized modifications or changes will void the EC Declaration of Conformity for
the device and operation of the device will no longer be permitted.
▪
The manufacturer is not liable for any damage, dangers or injuries that result from
unauthorized modifications and changes or due to the non-observance of the instruc-
tions in this manual.

Employee safety

➜ Ensure that the device is only operated by qualified specialist personnel and trained
employees.
➜ Observe the following instructions to avoid any personal injuries and property
damage:
- Laboratory regulations
- Accident prevention regulations
- Hazardous Substance Act
- Other generally accepted occupational health and safety regulations
- Local regulations
8
Safety Instructions

Safety during use


➜ Wear the appropriate protective clothing when working on the device (protective
glasses and, if necessary, safety gloves).
➜ Do not use the device in potentially explosive areas. The device is not protected
against explosion. There is no explosion or ATEX protection available.
➜ Do not carry out work with naked flames in the vicinity of the device (risk of
explosion).
➜ Do not operate or assemble devices in the vicinity which are emission or radiation
sources (electromagnetic waves) for the frequency range (3*10
➜ Do not operate or assemble appliances in the vicinity of the device which constitute
emission or radiation sources for ionizing radiation or in the ultrasonic range.
➜ Do not operate the device where adiabatic compression or shock waves might occur
(shock wave combustion).
➜ Do not use substances, where the energy input due to mixing might pose a hazard.
➜ Avoid putting pressure on the display when you are not operating the device.
➜ Do not spill liquids over the device or any parts of it.
➜ Remove any accidentally spilled liquids immediatly.
➜ Eliminate errors immediately.
➜ Do not use abrasive material to clean the surface. Only wipe with damp cloth.
➜ Always switch the device OFF after use.

Disposal


➜ Check the device components for hazardous substances and
solvents.
➜ Clean all components before disposal.
➜ Dispose of the device in accordance with the relevant national
regulations.
➜ Dispose of the packaging material in accordance with the
appropriate national regulations.
11 15
Hz to 3*10 Hz).
9