Operation
Saving a profile
As soon as all required ramps have been defined the profile can be saved:
➜
Use the push-and-rotary control to select the
the display.
➜
Press the push-and-rotary control to open the screen keyboard.
➜
Enter a profile designation here:
–
Use the push-and-rotary control to select the individual letters/numbers one
after the other.
–
Confirm each selection by pressing the push-and-rotary control.
–
Correct incorrect inputs with the
–
Then confirm the new designation with
Saving another profile with the same gear stage:
Back
➜
Press the
button to switch back to the higher-level menu to create further
profiles with the same gear stage.
–
The last stored profile is offered as a template by default.
–
Adjust the existing values as required and save the profile as described above.
Home
➜
Then press the
Saving another profile with a different gear stage:
To create other profiles with a different gear stage, proceed as follows:
➜
Follow the instructions to create a profile up to the input of the profile designation
(see previous section).
➜
After confirming the profile designation, if the last stored profile is offered as a
template, confirm with
–
With this selection, all the template's ramp data are deleted.
Home
➜
Use the
button to switch back to the Device menu.
➜
Determine the required gear stage, see section "Selecting the gear stage" on page
68.
Edit profile
➜
Open the
➜
Create a new profile with changed gear stage.
Correction
button to switch back to the Device menu.
Delete
.
submenu.
76
Save
symbol at the bottom edge of
button.
Save
.