Set Up The Device - Heidolph Hei-TORQUE Expert Betriebsanleitung

Commissioning

Set up the device

The described overhead stirrers can be mounted on a stand or on a wall grid. Any
necessary mounting materials are available as accessories, see www.heidolph.com.
Follow the safety instructions below:
WARNING
Risk of injury, risk of damage to property due to fall or tilting
If assembled improperly, the device can also fall or tip over when
unloaded!
➜
➜
After assembly of the overhead stirrer, check all screw connections
/ clamping screws for tight fit.
If the overhead stirrer is mounted on a wall grid, ensure that
the wall grid and all mounting elements have sufficient self-pro-
tection and load capacity!
When mounting the overhead stirrer on a stand, make sure that
the setup is sufficiently stable.
– The stand may only be set up on a stable surface.
– When mounting on a stand, follow the specific setup
instructions for the stand.
– Always align the overhead stirrer so that the quick-action
chuck vertically faces the notional centerline between the
long stand base bars, see following figure:
62