Device Activation Via Pc; Connection Setup - Heidolph Hei-TORQUE Expert Betriebsanleitung

Operation

Device activation via PC

WARNING
Unexpected device start-up
➜
➜
➜
The Hei-TORQUE Ultimate type devices provide two serial interfaces at the back of the
housing:
– 1 × USB Micro type AB (according to USB 2.0 spec. only up to max. 500 mA
– 1 × RS232 SUB D9
Use each of these interfaces to connect the device to a PC for external activation.
A PC can be used to activate up to four overhead stirrers.
Use the 1 m long USB interface cable supplied. If a longer cable is
used there is a risk of transmission errors!
The Hei-CONTROL software must be installed on the PC used for
external activation of the overhead stirrer.
A detailed description of the software and driver installation and
all information on the system requirements can be found in the
Hei-CONTROL operating instructions (Ref. 01-005-005-69), which
comes standard with the software.

Connection setup

➜ Ensure that all software and driver components on the PC are installed correctly
and that the PC is switched on.
➜ Switch on the overhead stirrer. The software detects the device automatically.
➜ As soon as the communication connection between the PC and overhead stirrer is
made, the overhead stirrer operates in remote mode. Make the necessary operating
settings in the software.
In remote mode the overhead stirrer is controlled via the software
on the connected PC.
On the overhead stirrer, only the swipe field for stopping the rota-
tional movement and the main switch are actively switched!
If the device is activated via a connected PC, note the possibility
of a start-up unexpected by third parties!
Ensure that any contact with rotating parts is prevented effec-
tively even when activated devices are at a standstill.
Secure the device accordingly with a clearly visible warning
sign and take further ambient-specific protective measures if
necessary.
78