Switch The Device On/Off; Operating Modes - Heidolph Hei-MIX Titramax 100 Betriebsanleitung

Operation
Operation

Switch the device on/off

To switch on and off, use the main switch on the front of of the device, see section
"Device description" on page 37.

Operating modes

The platform shakers described can be operated in continuous or timer mode.
Regardless of the operating mode selected, observe the following specific safety
instructions.
CAUTION
Risk of injury, risk of damage to property due to tilting/fall-
ing of the device
High shaking frequencies in combination with a large load and/or
a tall attachment assembly on the shaking platform may cause the
device to swing up and fall!
➜
➜
An uneven distribution of the load on the shaking platform may
cause the device to swing up and fall!
➜
➜
Risk of injury, risk of damage to property from falling ves-
sels
At high shaking frequencies, there is a risk that improperly fastened
vessels will fall off the shaking platform.
➜
Hand-arm over-exposure to vibration
Depending on the effort and the duration of use, there is a risk of
over-exposure to vibration of your hand and arm when using the
hand to hold the vessel during operation.
➜
Only gradually increase the shaking frequency to the required
level under the above conditions, paying attention to the
stability of the structure.
Lower the shaking frequency or reduce the total load on
the shaking platform when the device starts to move during
operation.
Always ensure that the vessels are evenly distributed on the
shaking platform.
Pay particular attention to an even distribution of the weight
load when vessels of different sizes and/or differently filled
vessels are placed on the shaking platform at the same time!
Before switching on the device, make sure that all vessels are
properly fixed on the shaking platform.
Observe the European Directive 2002/44/EC regarding the
permissible hand-arm vibration exposure.
41