Commissioning
Commissioning
Set up the device
CAUTION
Risk Of Slipping!
The vibration during operation can cause the device to move over
the mounting surface and/or fall to the ground.
➜
➜
Place the device on a solid level and horizontal surface for use.
➜
Before switching on, make sure that the device is sufficiently stable.
➜
Keep all contact surfaces clean and dry.
Power Supply
Always use the supplied power supply cord provided with the
device! Observe the instructions in section "Electrical safety" on
page 25.
The device must only be supplied with power from a properly
grounded mains socket-outlet.
Switch the device on/off
➜
Set the speed to zero before switching on the device. To do this, turn the speed
controller fully anti-clockwise.
➜
Use the on/off switch to turn the device on or off.
Observe the instructions for the correct positioning of the
device!
30