Mounting The Support Rod - Heidolph Hei-TORQUE Expert Betriebsanleitung

Commissioning
Commissioning

Mounting the support rod

The supplied support rod is used to fit the stirrer on a stand or a wall grid.
Insert the support rod in the receiving hole at the back of the stirrer so that the
screwed-in grub screw presses on the flat area of the support rod and thus fixes it
securely:
➜
Turn the grub screw clockwise to fix the support rod.
Tighten the grub screw by hand only and with the help of the hex
wrench supplied.
Make sure that you do not overtighten the grub screw, as this
damages the thread.
➜ Turn the grub screw counterclockwise to loosen and dismantle the support rod.
➜ Then fix the fitted support rod to an adequately load-bearing wall grid or a stand
with the help of suitable clamps (for suitable accessories, see www.heidolph.com).
61