Commissioning; Set Up The Device; Power Supply; External Temperature Controller (Hei-Plate Core Only) - Heidolph Hei-PLATE Mix 20 l Bedienungsanleitung

Commissioning

Commissioning

Set up the device

CAUTION
The vibration during operation can cause the device to move over the
mounting surface and/or fall to the ground.
➜
Place the device on a solid level and horizontal surface for use.
➜
Before switching on, make sure that the device is sufficiently stable.
➜
Keep all contact surfaces clean and dry to ensure the stability of the device during
operation.
➜
During operation, make sure that the required minimum distance of 10 cm between the
magnetic stirrer and other devices and structures is maintained (only devices with heating
function).

Power supply

Always use the supplied power supply cord provided with the device!
Observe the instructions in section „Electrical safety" on page 27.
The device must only be supplied with power from a properly grounded
mains socket-outlet.
The appliance inlet is located under the protective cover on the back of the device (figure:
Hei-PLATE Core. Hei-PLATE Mix 20 l without connection socket for external temperature
controller!)
➜
Lift the protective cover for connecting the power supply cable by hand. No tools are
required to open the protective cover.
As soon as the device is supplied via the power supply cable, the on/off button lights up white.

External temperature controller (Hei-PLATE Core only)

The six-pole connection socket for the external temperature controller EKT-HEI CON is located
under the protective cover on the rear of the device.
➜
Lift the protective cover for connecting temperature controller cable by hand. No tools are
required to open the protective cover!

Switching the device on/off

➜
To turn on the device, press the on/off button. When the device is switched on, the on/off
button lights up green.
➜
To turn off the device, press the on/off button again. When the device is turned off, the on/
off button lights up white.
30