Cleaning Oven; Fault; Troubleshooting - Angelo Po 2N1FAGF Bedienungshandbuch

To carry out this operation, proceed as follows.
Switch the appliance off and leave it to cool.
1)
Turn off the circuit-breaker to disconnect it
2)
from the electrical mains.
Remove the bottom plate (C) and the grid (D)
3)
from the oven and clean them thoroughly.
Clean the inside parts of the oven to remove
4)
any deposits which may impair its operation.
Dry the surfaces and reassemble the compo-
5)
nents.
Clean the rubber gasket on the oven door
6)
(avoid the use of corrosive products and do
not use abrasive materials or sharp tools).
The appliance has been tested before being put
into service. The information provided below
is intended to assist in the identifi cation and
correction of any anomalies and malfunctions
which might occur during use.
The user can solve some of these problems him-
self, but for others specifi c technical knowledge or
skill is required, and so they must only be carried
out by qualifi ed staff with recognised experience
acquired in the specifi c sector of operation.
Faults
Smell of gas.
The pilot light does not
ignite.
3301360_ut_GB_rev.1

CLEANING OVEN

If the gasket is damaged, do not use the oven
and contact the after-sales service.

FAULT

TROUBLESHOOTING

For all requirements contact the agents or
the headquarters of Angelo Po which can be
found in the contacts section of the website
http://www.angelopo.com.
Causes
Occasional leak because
fl ame has gone out.
The spark ignition devices are
not working.
Air in pipelines due to long
period out of use.
- 15 -
D
Important
Important
Remedies
Turn off the gas supply tap and
ventilate the room.
Check that the ignition devices are
in good working order. Light by
hand with a naked light.
Important
Contact the after-sales service.
Make more attempts to light the
fl ame.
C
ENGLISH
GB GB