Cleaning The Hob, Burners And Accessories - Angelo Po 2N1FAGF Bedienungshandbuch

Avoid leaving the components dirty for long
and, periodically,according to the intensity of
work (if necessary daily),proceed as indicated
below:
Switch the appliance off and leave it to cool.
1)
Remove the grill, the burner cap (A) and the
2)
burner (B).
Put them to soak in hot water with dish-
3)
washer soap.
Wash with a normal sponge and if necessary
4)
a scourer to remove any dirt thoroughly.
Check that the holes of the burner cap (A)
5)
are always completely clear for the regular
fl ow of gas. To remove possible dirt, insert
a metal rod (wire) into the hole and slide it
through until it is thoroughly clean.
Check the burner (B) ignition slot (cutoff ) is
6)
always completely clear for the normal fl ow
of gas. To remove any dirt, insert a blade like
a trimming knife in the slot, sliding it around
until it is thoroughly clean.
Carefully clean all the connecting parts
7)
between the burner cap (A) and the burner
(B). If necessary use a steel wire brush for
mechanics.
Clean every part of the hob with a suitable
8)
de-greaser.
Dry the surfaces and reassemble the parts.
9)
For the correct assembly of the burner (B)
GB
and burner cap (A), follow the directions
given in the illustration.
Turn on the burners for a few minutes to
10)
ensure a thorough drying and thus avoiding
the formation of rust.
3301360_ut_GB_rev.1

CLEANING THE HOB, BURNERS AND ACCESSORIES

Cautela - Avvertenza
Caution - Warning
Do not wash cast iron parts such as the
burners, burner caps and grills in a dish-
washer.
Caution - Warning
Never pour water or allow dirt to fall into
the burner as this will cause the burner to
malfunction or block the nozzle.
- 14 -
A
B
ENGLISH