Resetting The Appliance; Lengthy Downtimes Of Appliance; Instructions And Warnings For Use - Angelo Po 2N1FAGF Bedienungshandbuch

If the safety thermostat is tripped, the appliance
has to be restored to the initial working condi-
tions as follows.
Important
Before doing any work, cut off the mains
electricity supply.
Turn off the gas supply tap.
1)
Undo the screws (A) and remove the control
2)
panel (B).
Press the button (C) of the safety thermostat
3)
to restore the gas supply.
Replace the control panel (B) on completion
4)
of the operation.
Turn the gas supply tap back on and switch
5)
the main electricity supply back on.
If the appliance is to be out of use for a lengthy
period, proceed as follows.
Turn off the gas supply tap.
1)
Cut off the mains electricity supply using the
2)
appliance's master switch.
Clean the appliance and the surrounding
3)
areas thoroughly.
To ensure correct use of the appliance, the fol-
lowing rules should be adopted.
– Use only the accessories recommended by the
manufacturer.
– Check that the oven bottom plate is positioned
correctly.
– Check that the inspection hatch is closed.
– Allow the oven to warm up before using it.
– Do not use the oven with the door part open.
3301360_ut_GB_rev.1

RESETTING THE APPLIANCE

LENGTHY DOWNTIMES OF APPLIANCE

INSTRUCTIONS AND WARNINGS FOR USE

B
A
Spread a fi lm of edible oil over the stainless
4)
steel surfaces.
Carry out all the servicing procedures.
5)
Cover the appliance and leave a few gaps to
6)
allow air to circulate.
– When cooking in the oven, use the top guides
for cakes and the bottom guides for roasts.
– Place the pans on the grill only (provided
with the appliance), which must be correctly
inserted into the runners in the oven).
– Always keep the appliance and the surround-
ing areas clean.
– When cleaning, use only food-approved
detergents.
- 11 -
C
GB GB
ENGLISH