Calling Up The Configuration In Canape - HBM QuantumX Serie Bedienungsanleitung

QuantumX driver for CANape
5 QuantumX configuration

5.1 Calling up the configuration in CANape

In order to carry out measurements with a QuantumX module, you must
configure the module for the sensors or signals used. Once a QuantumX
module is set up in CANape, the setting can be carried out with the
QuantumX Assistant from within the CANape program. Do not call up the
Assistant via Windows to configure a module, as the information required by
CANape will only be generated when the QuantumX Assistant is closed after
having been opened via CANape. When a project is opened, the configuration
saved in CANape should be loaded into the module again so that CANape
has the latest version available. Any changes that you have made in the
meantime will however be lost.
1. Select Device -> Device configuration in CANape.
Fig. 5.1: Call up the configuration dialog
2. Click on Configure in the following dialog. This calls up the QuantumX
Assistant for the subsequent configuration.
A3325-1.0 en/de
15
HBM