Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
26
Fig. 5.13:
Signal adaptation dialog
In this dialog, select the Active filter type, the Filter characteristic, the Fil
ter frequency and the required Output rate.
Copy the settings (Copy in the Signals group or Ctrl‐C) to transfer them to
further channels. Mark the channels that should have the same settings and
then click on Paste in the Signals group or use Ctrl‐V.
The Number of post decimal places is determined solely by the number
displayed in the QuantumX Assistant. The measured values are transmitted to
CANape with full resolution.
5.9 Displaying measured values graphically in the
QuantumX Assistant (Scope)
The Scope tab in the Ribbon shows a diagram in the main window for the
display of the signals. Set the measurement conditions using the Ribbon and
specify the display options. Select the signals to be displayed via the Signals
tab in the Scope window.
HBM
QuantumX driver for CANape
A3325-1.0 en/de
Werbung
Inhaltsverzeichnis
