HBM QuantumX Serie Bedienungsanleitung Seite 19

QuantumX driver for CANape
Fig. 5.7: Component window Sensor database
As the HBM sensor database only contains general data for the various
sensors, you should set up your own sensor database (user database) with
the data from the calibration logs of your sensors if you do not use TEDS
sensors, see Section 5.5, Page 22.
If you do not use TEDS sensors or do not want to set up your own sensor
database, you will have to enter or calibrate the respective data for the
connected sensors again after every change or connection to a different
channel (column Amplifier setting, Fig. 5.8), as the information in QuantumX
is only saved for the actual channel (also refer to Section 5.5).
A3325-1.0 en/de
Sensor database (write‐protected) with HBM
sensors and general sensors (voltage, current,
thermocouples, etc.)
User database for own sensors
19
HBM