HBM QuantumX Serie Bedienungsanleitung Seite 23

QuantumX driver for CANape
permitted Excitation voltage for the sensor. Depending on the options of the
QuantumX module used, the next‐smallest available excitation voltage is set.
Fig. 5.11: Sensor database tab
Scaling depends on the data listed in the calibration certificate of the sensor,
in Fig. 5.11 this is 2.0131 mV/V (electrical span) for nominal load of 5000 N
(physical span). Calibration in the sensor database is not possible, but
Section 5.6 describes the procedure if you want to calibrate a sensor when
installed.
A3325-1.0 en/de
23
HBM