Mymode Switching Using The Remote Control; Changing Prosthesis Settings - Ottobock Genium Gebrauchsanweisung

7.5 MyMode Switching Using the Remote Control
INFORMATION
Advise your patient of the information in this section.
Once an active connection to the prosthesis has been established, the remote control can be used to switch between
MyModes.
1. Select mode in the main menu and confirm with the enter key.
2. A list of the available MyModes is displayed. Use
key. If the list of MyModes was called up accidentally, the active MyMode can be selected again.
• Feedback from the prosthesis: 1 long vibration signal
3. The remote control can be turned off by selecting and confirming "RC POWER OFF".
7.6 Changing Prosthesis Settings
INFORMATION
Advise your patient of the information in this section.
Once an active connection to the prosthesis has been established, the settings of the respective MyMode can be
changed using the remote control.
1. Select "DEVICE SETTINGS" from the main menu and confirm.
2. A list of available parameters for the current MyMode is displayed. Select the desired parameter and confirm.
3. A screen with a scale, the current parameter value and the limit values is displayed. Use
as desired and confirm with the enter key.
4. The list of parameters can be closed without making changes by selecting and confirming the arrow symbol. Press
to access the arrow symbol.
5. The remote control can be turned off by selecting and confirming "RC POWER OFF".
If the settings of another MyMode are to be modified, you must first switch to this MyMode (see Section 7.5 "MyMode
Switching Using the Remote Control").
Genium - Bionic Prosthetic System Genium - Bionic Prosthetic System
to select the desired MyMode and confirm with the enter
and 1 long beep signal
Remote Control Remote Control
.
to change the setting
Ottobock | 55 Ottobock | 55