4. WORK TO BE CARRIED OUT BY USER – IF NEEDED
4.1. Refuelling of the vehicle
For operation of the engine a mixture of unleaded fuel of octane number of ROZ
+ MON) / 2 and a fully synthetic 2-stroke oil at a mixing ratio of 1 : 50 (= 2 %).
Example:
Fill the required quantity of fully synthetic 2-stroke oil into a clean fuel jerrican.
Note:
Add unleaded fuel of an octane number of ROZ
Attention: A too high 2-stroke oil percentage (more than 2 %) can cause engine problems (e.g.
Attention: A too low 2-stroke oil percentage (less than 2 %) can cause engine problems (e.g.
Warning: Do not experiment with other fuels, this may cause damage to the engine and the
Warning: When preparing the fuel/oil mixture and when refuelling, never handle with open
Warning: Never mix or refill fuel in closed rooms. Handle fuel only in well vented places!
Note:
Shake fuel jerrican vigorously.
Fill fuel tank of the vehicle with a suitable device (funnel).
Close fuel tank and jerrican immediately after refuelling.
Warning: Shake the jerrican with the fuel/oil mixture vigorously before every re-fuelling to
Warning: The vehicle must only be refuelled when engine is stopped and the ON/OFF switch
Warning: Do not allow fuel to come into contact with hot engine parts or accessories – risk of
Seite/page 88/132
Downloaded from
www.Manualslib.com
For 10 litres of fuel add 0,20 litre 2-stroke oil.
For 2,5 gal fuel add 0,05 gal 2-stroke oil.
Normally no special KART 2-stroke oil is necessary.
calculated ratio into the jerrican.
carbonization of the exhaust valve).
piston seizure).
intake system.
light or fire. Fuel and fuel vapours are easily inflammable and explosive!
Do not fill the fuel jerrican brim-full.
assure sufficient blending of the mixture.
is at OFF position.
inflammation and explosion!
ROTAX KART RM1
manuals search engine
Operator`s Manual RM1
95 or 91 (RON + MON) / 2 at the
min.
95 or 91 (RON
min.
Ausgabe/Edition 01/2006