Change Of Gear Oil - Rotax Rm1 Benutzerhandbuch

4.14.
During the first 5 operating hours wear is highest. For this reason the gear oil must be changed
after the first 5 operating hours (and then after every 50 operating hours).
Proceed as follows:
Open the oil drain screw (pos. 2).
Collect the drained oil in a suitable
container.
Note:
Clean the oil drain screw.
Fit the oil drain screw and tighten it
with 20 Nm (177 lb. in.).
Open the oil refill screw (pos. 1).
Fill in 0,25 l (0.066 gal.) of motor oil of quality SAE 15 W 40.
Check the oil level at the inspection glass.
Hand tighten the oil refill screw (pos.1)
Attention: Never use the engine without
Seite/page 109/132
Downloaded from www.Manualslib.com

Change of gear oil

Dispose of the old
according to the regulations of
your country.
motor oil, this would damage the
engine.
ROTAX KART RM1
manuals search engine
Operator`s Manual RM1
oil
Ausgabe/Edition 01/2006