Inhaltsverzeichnis
Werbung
GB
3. Tighten the guard plate on the fixing part
(03/4) from below with both screws (04/4) Ø5
x 35 mm.
4. Tighten both screws (03/5) firmly. 4.3
Fitting the blade (05)
WARNING!
Danger of serious
The blade can become
undone during operation
and cause serious injury
due to a locking nut that
starts to turn easily.
■
Immediately replace the
locking nut if it becomes
easy to turn.
1. Place the trimmer so that the cutting head
(05/1) is pointing upwards.
2. Push the blade (05/2) onto the pressure fitting
(05/3).
Note: The recess of the pressure fitting must
fit perfectly into the drill hole of the blade.
3. Put on the pressure disk (05/4).
4. Put on the rider plate (05/5).
5. Check that all positioned components are
centred.
6. Screw the locking nut (05/6) onto the shaft,
but do not tighten yet.
Note: Left-hand thread. Tighten the locking
nut in an anti-clockwise direction.
7. Insert the support pin (05/7) to block the shaft.
8. Tighten the locking nut firmly.
Note: The locking nut must be hard to turn.
Replace if it is easy to turn.
9. Check that the blade is firm and centred. If
not, correct.
10. Remove the support pin again.
4.4
Installing the spool (06)
1. Insert the support pin (06/1) to block the shaft.
2. Put on the pressure disk (06/2).
3. Put on the anti-wrap guard (06/3) with the
labelled part pointing towards the cutting head
(06/4).
66
4. Screw the spool (06/5) onto the shaft and
5. Attach the guard bar (06/6) with integrated
injury!
6. Remove the support pin.
5 START-UP
5.1
1. Put on the carrying belt (see chapter 6.2
2. Hook the snap hook (07/1) into the eye (07/2)
Checking the length of the carrying belt
1. Carry out several horizontal sweeping
2. If not: Adjust the length of the carrying belt
Balancing the trimmer
1. Release the attached trimmer. The blade or
2. If not: Hook the snap hook (07/1) into another
Operation
5.2
tighten.
Note: Left-hand thread. Tighten the spool in
an anti-clockwise direction.
line cutter to the guard plate, then screw in
the plastic securing bolt (06/7). Note: The
plastic securing bolt is already screwed into
the guard plate on delivery. Warning: Never
use the spool without the guard bar and line
cutter.
NOTE
Inspect the appliance for damage
every day before starting work, if it is
dropped or is subjected to other
impacts. Have any damage repaired
before putting the appliance into
operation.
Adjusting the carrying belt (07)
"Putting on the carrying belt (10)", page 47).
on the appliance.
movements above the ground without starting
the engine (07/a). The cutting head must
always move above the floor at the same
height.
and repeat the sweeping movements.
spool must stop swinging approx. 10 cm
above the ground.
eye (07/2) on the appliance and balance
again.
Mixing and pouring in the petrol/oil
mixture (08)
Start-up
132, 141
Werbung
Inhaltsverzeichnis
