AL-KO solo 132 Betriebsanleitung Seite 65

4. Place on the upper half shell and lightly
screw in the fixing screw.
5. Align the "Bike" handle in such a way that
distance A is smaller than distance B (02/A,
02/B).
Note: Always guide the trimmer to the right
of your body using the "Bike" handle. Both
distances are correct when the middle of the
cutting head coincides with the middle of the
body.
6. Tighten the fixing screw firmly.
4.2 Installing the guard plate (03, 04)
Attach the guard plate from above (03)
1. Place the trimmer so that the cutting head
(03/1) is pointing downwards.
2. Lift the shaft (03/2) on the cutting head and
push the guard plate (03/3) towards the
cutting head up to the stop (03/a). Then set
down the shaft and guard plate again.
3. Tighten the fixing part (03/4) onto the guard
plate with both screws (03/5) Ø5 x 20 mm.
Do not tighten the screws firmly yet.
Attach the guard plate from below (04)
1. Place the trimmer so that the cutting head
(04/1) is pointing upwards.
2. Correct the position of the guard plate (04/2)
so that the drill holes (04/3) of the guard
plate and fixing part (03/4) are above each
other.
2500126_a 65