Cleaning The Unit - Sanyo DC-007C Handbuch

To check the timer settings
Press the TIMER button repeatedly. The timer settings are displayed in
the following order:
On time v Off time v Timer mode/Function v Original display
returns
To change the settings, press the TIMER button to select the setting to be
changed, then press the MEMORY button so that the display blinks.
Change the setting as explained above.
To release the timer
After turning the power on, press the TIMER button, then the SET/CLEAR.
To set the timer again with the same settings
1. Press the TIMER button, then the SET/CLEAR.
2. Press the z/ON button to switch off the power.
Note:
- If the SET/CLEAR button is pressed while the timer is being set, the
original display returns.
- The timer mode is released if a power failure occurs during timer
controlled operation.
- The timer may not operate if a power failure occurs during timer
operation standby mode.
Using the sleep timer
(Remote control only)
The sleep timer automatically switches off the power after a preset time
has elapsed. The volume will gradually be reduced (fade-out) during the
1-minute period before the unit turns off. There are 12 time periods
available: 120, 110, 100, 90, 80, 70, 60, 50, 40, 30, 20, and 10 minutes.
Press the SLEEP button repeatedly to select the desired sleep time.
SLEEP
After several seconds, the original display returns and the brightness of
the display reduces. "SLEEP" blinks.
To check the remaining sleep time
Press the SLEEP button once. After several seconds, the original display
returns.
To release the sleep timer while in operation
Press the SLEEP button repeatedly until "SLEEP" disappears. The timer
is also released if the power is switched off.
MAINTENANCE
Cleaning the tape head (Tape deck)
To ensure continued high performance, use cotton swab to clean the
heads, pinch rollers and capstans after about every 10 hours of use
(Fig. 26). If the dirt persists, soak the swab in a little methylated spirit or
head cleaning fluid and then clean.

Cleaning the unit

Clean the outside of the unit with a clean soft cloth, moistened with
lukewarm water. Do not use benzene, thinner or alcohol since they will mar
the finish of the surfaces.
22