Agilent Technologies 6890N Benutzerhandbuch Seite 292

Fehlermeldungen
Tabelle 27 (Fortsetzung)
Fehler- Statusmeldung
code
273 B det bad cksum
274 Pneu aux bad cksum
275 F inlet bad fact cal
276 B inlet bad fact cal
277 F det bad fact cal
278 B det bad fact cal
279 P aux bad fact cal
280 F inlet i/o failure
281 B inlet i/o failure
282 F det i/o failure
283 B det i/o failure
284 Pneu aux i/o failure
285 F det adjust failure
286 B det adjust failure
290 Zones not updating
293 Zone heater driver
Popup-Meldung
Back detector: invalid
module checksum
Pneu aux module: invalid
module checksum
Front inlet: invalid
constants from factory
calibration
Back inlet: invalid
constants from factory
calibration
Front detector: invalid
constants from factory
calibration
Back detector: invalid
constants from factory
calibration
Pneumatics aux invalid
constants from factory
calibration
Front detector offset
adjustment failed
Back detector offset
adjustment failed
Zones not updating
Zone heater driver
Run log
Not ready:
F det adjust failure
Not ready:
B det adjust failure
Not ready:
Zones not updating
Not ready:
Zone heater driver
Meldungen
Bemerkungen
282 282