Agilent Technologies 6890N Benutzerhandbuch Seite 290

Fehlermeldungen
Tabelle 27 (Fortsetzung)
Fehler- Statusmeldung
code
241 Invalid line sense
242 Aux 3 faulty fact cal
243 Aux 4 faulty fact cal
244 Aux 5 faulty fact cal
245 F det module rev
246 B det module rev
247 F inlet module rev
248 B inlet module rev
249 Aux module rev
250 F det wrong module
251 B det wrong module
252 F inlet wrong module
253 B inlet wrong module
254 Aux wrong module
Popup-Meldung
Line sense reading
thermal shutdown
Pneu aux module invalid
constants from factory
calibration
Pneu aux module invalid
constants from factory
calibration
Pneu aux module invalid
constants from factory
calibration
Front det module:
obsolete EEPROM
Back det module: obsolete
EEPROM
Front inlet module:
obsolete EEPROM
Back inlet module:
obsolete EEPROM
Pres aux module: obsolete
EEPROM
Front det: non-det module
Back det: non-det module
Front inlet: non-
inletmodule
Back inlet: non-
inletmodule
Non-aux module in pneu
aux position
Run log
Not ready:
Thermal shutdown
Not ready:
Aux 3 faulty fact cal
Not ready:
Aux 4 faulty fact cal
Not ready:
Aux 5 faulty fact cal
Not ready:
F det module rev
Not ready:
B det module rev
Not ready:
F inlet module rev
Not ready:
B inlet module rev
Not ready:
Aux module rev
Not ready:
F det wrong module
Not ready:
B det wrong module
Not ready:
F inlet wrong module
Not ready:
B inlet wrong module
Not ready:
Aux wrong module
Meldungen
Bemerkungen
280 280