Agilent Technologies Turbo-V 301-AG Bedienungshandbuch Seite 244

17 Technical Information
Examples
216 R N
224 R A
226 R N
300 R N
301 R N
302 R N
320 Reserved to Agilent service
to 399
400 R A
402 R A
404 R A
500 Reserved to Agilent service
503 R/W N
504 R/W L
1. Automatic means that when the controller stops, the vent valve is opened with
NOTE
a delay defined by window n. 126; when the controller starts, the vent valve is
immediately closed.
2. On command means that the vent valve is opened or closed by means of
window n. 122.
Figure 28
244/294
Controller Air Temperature (°C).
Pressure reading Format = X.X E XX
Rotation Frequency (rpm)
Cycle time in minutes (zeroed by the reset
command)
Cycle number (zeroed by the reset
command)
Pump life in hours (zeroed by the reset
command)
CRC EPROM (QE)
CRC Param. (PA)
CRC Parameter structure
RS 485 address
Serial type select
7 6 5
TOO HIGH LOAD
SHORT CIRCUIT
OVERVOLTAGE
AUX FAIL
Window N. 206 Bit Description
Turbo-V 301-AG Rack Controller User Manual / 87-900-982-01
0 to 999999
0 to 9999
0 to 999999
QE8XXXX (where "XXXX" are
variable)
PA8XXXX (where "XXXX" are
variable)
"XXXX"
0 to 31 (default = 0)
0 = RS 232
1 = RS 485 (default = 0)
4 3 2 1 0
NO CONNECTION
PUMP OVERTEMP.
CONTROLL. OVERTEMP.
POWER FAIL
(F)