Lenze 8200 motec Montageanleitung Seite 129

Code
No. Name
C0148* Motor
parameter

identification
C0517* User menu

1 Memory 1
2 Memory 2
3 Memory 3
4 Memory 4
5 Memory 5
6 Memory 6
7 Memory 7
8 Memory 8
9 Memory 9
10 Memory 10
L
The most important codes for commissioning
Possible settings
Lenze Selection
0
0 Ready
1 Start identification
V/f-rated frequency (C0015),
slip compensation (C0021) and
motor stator inductivity (C0092)
are calculated and saved.
The motor stator resistance
(C0084) = total resistance of
motor cable and motor is
measured and saved
50 C0050 Output frequency (MCTRL1-NOUT)
34 C0034 Analog setpoint selection range
7 C0007 Fixed configuration - digital input
signals
10 C0010 Minimum output frequency
11 C0011 Maximum output frequency
12 C0012 Acceleration time main setpoint
13 C0013 Deceleration time main setpoint
15 C0015 V/f rated frequency
16 C0016 U
min
2 C0002 Parameter set transfer
EDK82MV222 DE/EN/FR 9.0
Commissioning
boost
T
IMPORTANT
Only when the motor is
cold!
1. Inhibit controller, wait until
drive is in standstill
2. Enter the correct motor
data under C0087, C0088,
C0089, C0090, C0091
(see motor nameplate).
3. Set C0148 = 1 by 
4. Enable controller
The identification
– starts,  goes off
– the motor makes a
high-pitched tone, but
does not rotate!
– takes approx. 30 s
– is completed when 
is on again
5. Inhibit controller
After mains switching or
when using the function
 the code from
C0517/1 will be displayed.
In Lenze setting, the user
menu contains the most
important codes for
starting-up the control
mode "V/f characteristic
control with linear
characteristic"
When the password
protection is activated,
only the codes entered
under C0517 are freely
accessible.
Enter the required code
numbers in the subcodes.
Codes, which are only
active when being used
together with an
Application-I/O, cannot be
entered!
NOV