Lenze 8200 motec Montageanleitung Seite 110

T
Commissioning
Selection of the correct operating mode
léÉê~íáåÖ ãçÇÉë êÉÅçããÉåÇÉÇ Ñçê ëí~åÇ~êÇ ~ééäáÅ~íáçåë
qÜÉ ÑçääçïáåÖ í~ÄäÉ ÜÉäéë óçì íç ÑáåÇ íÜÉ ÅçêêÉÅí çéÉê~íáåÖ ãçÇÉ Ñçê ëí~åÇ~êÇ
~ééäáÅ~íáçåëW
Application
Single drives
With extremely alternating loads
With high starting duty
With speed control (speed feedback)
With high dynamic response (e. g. positioning and infeed drives)
With torque setpoint
With torque limitation (power control)
Three-phase AC reluctance motors
Three-phase sliding rotor motors
Three phase motors with assigned frequency-voltage characteristic
Pump and fan drives with square-law load characteristic
Group drives
(several motors connected to one controller)
Identical motors and identical loads
Different motors and/or changing loads
`MMNQ Z OW äáåÉ~ê sLÑ ÅÜ~ê~ÅíÉêáëíáÅ Åçåíêçä
`MMNQ Z PW ëèì~êÉJä~ï sLc ÅÜ~ê~ÅíÉêáëíáÅ Åçåíêçä
`MMNQ Z QW îÉÅíçê Åçåíêçä
`MMNQ Z RW ëÉåëçêäÉëë íçêèìÉ Åçåíêçä
NNM
EDK82MV222 DE/EN/FR 9.0
Operating mode
Setting in C0014
recommended alternatively
4
4
2
2
5
2
2
2
2
3 2 or 4
2
2
L
2
2
4
-
-
4
-
-
-
-
-