Wiring According To Emc Requirements - Lenze 8200 motec Montageanleitung

`çåÇáíáçåë Ñçê íêçìÄäÉJÑêÉÉ çéÉê~íáçåW
bñÅÉéí Ñçê íÜÉ ã~áåë Å~ÄäÉI ìëÉ ëÜáÉäÇÉÇ Å~ÄäÉë çåäóK
qÜÉ ëÜáÉäÇ ãìëí ÄÉ Å~êÉÑìääó ÅçååÉÅíÉÇ íç mbK
`çååÉÅí ãçíçê ~åÇ ã~áåë mb ÅçåÇìÅíçêë íç ëÉé~ê~íÉ mb íÉêãáå~äëK
^
_
`
a
cáÖK NM
Mains cable L1, L2, L3, PE

PE connection - mains cable

PE connection - motor

Shielded control cable

Shield connection for control cable (screw shield to shield sheet)

PE connection - terminal strip X2

Isolated terminal (e.g. star point for motor star connection)

Function module

X1 Terminal strip - mains connection
X2 Terminal strip - motor connection
PES HF shield connection by connecting the shield with a surface as large as possible to PE
L

Wiring according to EMC requirements

uN
b
EDK82MV222 DE/EN/FR 9.0
Motor mounting
uO
c
d
e
8200mot101
P
Shield connection
1. Prepare cable
2. Route the cable
through the eyebolt
of the shield and
bend the eyebolt.
3. Tighten the screw.
The shield must be
tightly connected to
the shield sheet.
0.7 Nm
6 lb-in
PES
VV