Lenze 8200 motec Montageanleitung Seite 120

T
Commissioning
The most important codes for commissioning
Code
No. Name
C0002*
Parameter set
management

-11-
uSEr
Restorage of
default setting
C0002* Parameter set
transfer using

the keypad
uSEr
(cont.)
NOM
Possible settings
Lenze Selection
0 0 Ready
1
Lenze setting
2
Lenze setting
3
Lenze setting
4
Lenze setting
31
Lenze setting
61
Lenze setting
62
Lenze setting
63
Lenze setting
64
Lenze setting
Keypad
70 With function module
Application-I/O, INTERBUS,
PROFIBUS-DP, LECOM-B,
DeviceNet/CANopen
10 With all other function modules
EDK82MV222 DE/EN/FR 9.0
PAR1
PAR2
PAR3
PAR4
FPAR1
PAR1 + FPAR1
PAR2 + FPAR1
PAR3 + FPAR1
PAR4 + FPAR1
Controller
IMPORTANT
PAR1 ... PAR4:
Parameter sets of the
controller
PAR1 ... PAR4 also contain
parameters for
Standard-I/O,
Application-I/O,
AS interface or system
bus (CAN)
FPAR1:
Module-specific
parameter set of the
fieldbus function modules
INTERBUS, PROFIBUS-DP,
LECOM-B,
DeviceNet/CANopen
FPAR1 is saved in the
function module
Restorage of default setting
in the selected parameter set
Restorage of default setting
in the fieldbus function
module
Restorage of default setting
in the selected parameter set
of the controller and the
fieldbus function module
Use the keypad to transfer
parameter sets to other
controllers.
During transfer the
parameters cannot be
accessed via other
channels!
All available parameter sets
(PAR1 ... PAR4, and FPAR1)
are overwritten with the
corresponding keypad data
L