Werbung
WARNING! Starter cord kickback (rapid
retraction) will pull hand and arm toward engine
faster than you can let go which could cause
broken bones, fractures, bruises, or sprains resulting in
serious injury. NEVER pull starter cord without first
relieving spray gun pressure. When starting engine, pull
cord slowly until resistance is felt and then pull rapidly to
avoid kickback. Firmly grasp spray gun with both hands
when using high pressure spray to avoid injury when spray
gun kicks back.
3. Return recoil handle slowly. DO NOT let rope "snap
back" against starter.
WARNING! The high pressure stream of water
that this equipment produces could cut through
skin and its underlying tissues, resulting in serious
injury and possible amputation. If cut by fluid, call physician
immediately. DO NOT treat as a simple cut. DO NOT allow
CHILDREN to operate pressure washer. NEVER aim spray
gun at people, animals, or plants. DO NOT secure spray
gun in open position. DO NOT leave spray gun unattended
while machine is running. NEVER use a spray gun which
does not have a trigger lock or trigger guard in place and in
working order. NEVER connect high pressure hose to
nozzle extension.
WARNING! Contact with muffler area could
cause burns resulting in serious injury. DO NOT
touch hot parts and AVOID hot exhaust gases.
Allow equipment to cool before touching.
WARNING! Contact with power source could
cause electric shock or burn resulting in death or
serious injury. NEVER spray near power source.
7-in-1 Nozzle Figure
7-in-1 nozzle allows you to switch between seven different
spray pattern nozzles once spray gun trigger is locked.
To change nozzle patterns:
1. Select desired spray pattern:
•
Select Maximum 0° (A) nozzle setting for stubborn or
hard to reach surface such as second story surfaces,
paint removal, oil stains, rust removal or other
stubborn substances (tar, gum, grease, wax, etc.).
•
Select General 15° (B) nozzle setting for tougher
cleaning tasks. Ideal for removing grease and dirt
from hard surfaces. Also capable of stripping paint
when held at a 45° angle.
•
Select Gentle 40° (C) nozzle setting for gentle
cleaning of cars/trucks, boats, RV's, patio furniture,
lawn equipment, etc.
•
Select Fan Spray (D) nozzle setting for optimal
high flow rinsing away of light dirt and debris.
•
Select Fan Spray with Soap (E) nozzle setting for
delicate surface cleaning of cars, trucks, childrens
play equipment, patio furniture, etc.
•
Select Extended Reach (F) nozzle setting for quick
high flow clean up and long reach cleaning of
second story siding and windows.
•
Select Extended Reach with Soap (G) nozzle setting
to propell soap to second story siding and windows.
2. Turn dial until desired spray pattern lines up with arrow
on 7-in-1 nozzle.
11
Usage Tips
• In High Pressure Mode, keep 7-in-1 nozzle 20 to 61 cm
(8 to 24 in.) away from cleaning surface.
• If you get the 7-in-1 nozzle too close, you may
damage surface being cleaned.
• DO NOT get closer than 15 cm (6 in.) when cleaning
tires.
Applying Detergent
WARNING! Chemicals could cause burns
resulting in death or serious injury. DO NOT use
caustic liquid with pressure washer. Use ONLY
pressure washer safe detergents/soaps. Follow
manufacturers instructions.
To apply detergent:
1. Remove cap from detergent tank, fill with appropriate
detergent and replace cap.
2. Select a soap nozzle setting.
NOTICE Detergent cannot be applied with non soap
nozzle setting (maximum, general, gentle, fan spray or
extended reach).
3. Apply detergent to a dry surface, starting at lower
portion of area to be washed and work upward, using
long, even, overlapping strokes.
4. Allow detergent to "soak in" per detergent
manufacturer's instructions.
Pressure Washer Rinsing
For Rinsing:
1. Select a non soap nozzle setting.
WARNING! Kickback from spray gun (29 N) could
cause you to fall resulting in death or serious injury.
Operate pressure washer from a stable surface. Be
extremely careful if you must use the pressure washer from
a ladder, scaffolding, or any other similar location. Firmly
grasp spray gun with both hands when using high pressure
spray to avoid injury when spray gun kicks back.
2. Apply a high pressure spray to a small area and check
surface for damage. If no damage is found, continue rinsing.
3. Start at top of area to be rinsed, working down with
same overlapping strokes as you used for cleaning.
Automatic Cool Down System (Thermal Relief)
Circulating water in pump can reach temperatures above
51°C (125°F) if running pressure washer for 3-5 minutes
without pressing trigger on gun. The system engages to
cool pump by discharging warm water onto ground.
7
Werbung
Kapitel
Fehlerbehebung
