Raising Or Lowering The Gatch - Electric Litter Option - Not Available With Prime X Option; Positioning The Recovery Chair - Not Available With Prime X Option - Stryker Prime Series Stretcher Bedienungsanleitung

English
Raising or lowering the gatch - electric litter option - not available with Prime X
EN
option (Continued)
To raise the gatch, press up on the gatch side of the siderail patient control panel or the foot end operator control panel.
To lower the gatch, press down on the gatch side of the siderail patient control panel or on the foot end operator control
panel.
Note: Always plug the power cord into a grounded, hospital grade wall outlet.

Positioning the recovery chair - not available with Prime X option

WARNING
Always operate the product when all operators are clear of the mechanisms.
To place the product in the recovery chair position
1. Raise the Fowler backrest to a seated position
1-28 or Raising or lowering the Fowler backrest - electric litter on page
Note: To position the recovery chair, the product must have the Lift Assist backrest option and the gatch option.
2. Raise the gatch to the full up position
option on page 1-29
page 1-29).
3. Raise the litter to the highest height
on page 1-22).
4. Place the product into the Reverse Trendelenburg position
page 1-23).
5. Reverse steps to lower the product to the flat position.
1-30
Operation
(Figure 1-12 on page
(Raising or lowering the Fowler backrest - non-electric litter on page
(Raising or lowering the gatch - non-electric litter - not available with Prime X
or Raising or lowering the gatch - electric litter option - not available with Prime X option on
Figure 1-12: Recovery chair
(Raising the non-electric litter on page 1-21
1115-409-005 REV E
1-30):
1-28).
or Raising the electric litter option
(Positioning the product in Reverse Trendelenburg on
www.stryker.com