Converting The Defibrillator Tray/Foot Extender To A Defibrillator Tray - Stryker Prime Series Stretcher Bedienungsanleitung

Converting the defibrillator tray/foot extender to a defibrillator tray

WARNING
• Do not place items that weigh more than 30 lb (14 kg) on the defibrillator tray/foot extender. Always strap down all
devices that you place on the defibrillator tray.
• Always use caution if the defibrillator tray/foot extender, footboard/chart holder, or upright oxygen bottle holder is
attached to avoid pinching your fingers when you position the foot end push handle option.
CAUTION
Always raise the IV pole before you attach the defibrillator tray/foot extender to the product. If you do not raise the IV
pole, the foot extender will not operate.
To convert the defibrillator tray/foot extender to a defibrillator tray:
1. Pull out the top knob (A)
2. Pivot the defibrillator tray (B) until the tray is flat over the foot end of the product. Release the top knob (A). Make
sure that the defibrillator tray is locked in place.
3. Use the strap to secure devices to the defibrillator tray.
Notes
• Do not use the defibrillator tray/foot extender as a push/pull device. Product damage may occur.
• Do not attach items to the foot extender.
www.stryker.com
Accessories
(Figure 1-14 on page 1-37).
A
D
Figure 1-14: Defibrillator tray/foot extender
1115-409-005 REV E
B
C
English
EN
1-37