orbit controls OCM160 Betriebsanleitung Seite 71

OCM160 Precision DC Calibrator
Value is not affected by reset
Example:
SYST:BEEP:VOL 0.2
:SYSTem:BEEPer:KEYBoard
Syntax:
:SYSTem:BEEPer:KEYBoard <BOOL>
:SYSTem:BEEPer:KEYBoard?
Description:
This command sets state of keyboard beeper.
Parameters:
<BOOL>
·ON
·OFF
·1
·0
Remarks:
Overlapped command
Example:
SYST:BEEP:KEYB ON
SYST:BEEP:KEYB? Response: 1
:SYSTem:COMMunicate:BUS
Syntax:
:SYSTem:COMMunicate:BUS <CPD>
:SYSTem:COMMunicate:BUS?
Description:
This command selects communication interface.
Parameters:
<CPD>
·SERial
·GPIB
·USB
·LAN
Remarks:
Sequential command
Value is not affected by reset
Example:
SYST:COMM:BUS SER
SYST:COMM:BUS? Response: SER
:SYSTem:COMMunicate:GPIB:ADDRess
Syntax:
:SYSTem:COMMunicate:GPIB:ADDRess <DNPD>
:SYSTem:COMMunicate:GPIB:ADDRess?
Description:
This commands allows set communication GPIB address
Parameters:
<DNPD>
Remarks:
Overlapped command
Value is not affected by reset
Example:
SYST:COMM:GPIB:ADDR 2
SYST:COMM:GPIB:ADDR? Response: 2
71
SYST:BEEP:VOL? Response: 2.000000E-01
{ON|OFF|1|0} (default 1)
device system beeper is enabled
device system beeper is disabled
same as ON
same as OFF
{SERial|GPIB|USB|LAN} (default SER)
RS232 interface
GPIB interface
USB interface
LAN interface
Range 1 ... 31 (default 2)
Orbit Controls AG
Owner's Manual