orbit controls OCM160 Betriebsanleitung Seite 52

Orbit Controls AG
·ON
·OFF
·1
·0
Remarks:
The value is stored in each preset
The value is set according to "Startup" preset after power on
The value is set to default on *RST command
Overlapped command
Example:
OUTP:RES:COMP ON
OUTP:RES:COMP? Response: 1
:OUTPut:FREQuency:PULL
Syntax:
:OUTPut:FREQuency:PULL <BOOL>
:OUTPut:FREQuency:PULL?
Description:
This command connects the internal pull-up resistor (50 Ω) to the Frequency output.
Parameters:
<BOOL>
·ON
·OFF
·1
·0
Remarks:
The value is stored in each preset
The value is set according to "Startup" preset after power on
The value is set to default on *RST command
Overlapped command
Example:
OUTP:FREQ:PULL ON
OUTP:FREQ:PULL? Response: 1
[:SOURce]:VDC[:AMPLitude]
Syntax:
[:SOURce]:VDC[:AMPLitude] <DNPD>[<UNIT>]
[:SOURce]:VDC[:AMPLitude]?
Description:
This command sets voltage amplitude in Voltage function. Node SOUR:VDC also
selects Voltage function if not already selected.
Parameters:
<DNPD>
<UNIT>
·V
Remarks:
The value is stored in each preset
The value is set according to "Startup" preset after power on
The value is set to default on *RST command
Overlapped command
Example:
VDC 10.0
VDC? Response: 1.000000E+01 V
Owner's Manual
selsects 4-wire connection
selsects 2-wire connection
same as ON
same as OFF
{ON|OFF|1|0} (default 0)
connects pull-up resistor
disconnects pull-up resistor
same as ON
same as OFF
Range -100.0 ... 100.0 (default 10.0)
{V}
Volt
OCM160 Precision DC Calibrator
52